







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterPaver Driveway Cost in Los Angeles: What the Spec Sheet Actually Says
A paver driveway in Los Angeles runs $8,260 to $21,240 installed, edge restraint, polymeric sand and sealing included. That range isn’t a national average pulled off a widget – it’s what the work costs here, where two local conditions decide the number before a single paver is set: LA’s stormwater rules on impervious surface, and the expansive clay under most Valley and Eastside lots. Call Bradford Remodeling Co Los Angeles at (844) 343-6681 for a written price before anything is ordered. Live person answers, day or night.

Why an LA driveway costs more than the same job in Phoenix
Up to roughly 500 square feet of new driveway is where the first cost fork appears. Above that, LA’s urban runoff and low-impact development requirements – enforced through the Bureau of Sanitation – can require the project to manage the stormwater its new impervious surface sheds. In practice that means one of three compliant solutions, and each changes your spec and your base-preparation line.
- Permeable pavers with open-graded base: water infiltrates through the joints and stone layers instead of running off. Adds material cost and a deeper excavation, typically 8 to 15 percent on the assembly.
- Bioretention strip at the driveway edge: a planted, engineered low point that catches and filters runoff. Adds excavation, soil amendment and plantings, usually a few thousand dollars depending on length.
- Dry well or catch basin with infiltration trench: a below-grade pit connected to the drive by buried pipe. Costs more to dig and inspect, but preserves your paver layout and color choices.
The honest part: whether your specific project trips the threshold depends on the square footage, whether you’re replacing an existing hard surface or adding new impervious area, and what LADBS plan check asks for on your parcel. We confirm that before pricing, not after. If you’re weighing materials against each other, our main construction services page covers how driveway, concrete and hardscape scopes differ on the same lot.
Expansive clay and the base course nobody quotes you for
Standard paver installation calls for a 4-inch compacted base course. On a lot with verified expansive clay – which is most of the San Fernando Valley and large stretches of the Eastside – 4 inches is the wrong spec. These soils swell when they take on water and shrink hard through the long dry season, and the clay doesn’t stay put under a driveway. The correct build is 6 to 8 inches of compacted base over woven geotextile fabric, with the fabric keeping fine clay particles from migrating up into the stone and opening voids under the pavers.
Skip it and the failure is predictable. Within about two years you get paver movement, joint sand washing out in the first winter rains, and lippage where one unit sits proud of its neighbor. The repair means pulling pavers, re-excavating and rebuilding the base – paying twice for the same square footage. The thicker base and fabric add cost on the front end. They’re the line item that makes the driveway stay flat.
If your lot also carries a home that needs work inside, our Los Angeles service area page lays out the remodeling side of what we handle in this city.

The hillside grade question, and where product choice gets narrowed for you
Driveways steeper than 20 percent grade – common in Silver Lake, Echo Park and the Hollywood Hills – require textured or saw-cut pavers for slip resistance. That’s a code-driven product decision, not a design preference. It narrows your color and profile options, and it adds cost per square foot because saw-cut faces and textured surfaces are a more expensive manufacturing run. If your lot carries the hillside grading and slope-density scrutiny this city is known for, we get the grade verified before the paver line is quoted.
Paver Driveway Cost in Los Angeles: Line-Item Pricing
These are the market ranges we work from. Full assembly means the paver, the base, edge restraint, polymeric sand and sealing – not just the paver unit price a homeowner sees at a supplier counter.
| Item | Installed Cost Range |
|---|---|
| Paver driveway installation, full assembly | $8,260 - $21,240 |
| Concrete driveway installation | $5,310 - $14,160 |
| Asphalt driveway paving | $4,130 - $10,620 |
| Driveway replacement | $5,900 - $16,520 |
| Driveway sealing | $295 - $825 |
| Paver patio installation | $4,130 - $12,980 |
How Belgard’s tiers map to real per-square-foot numbers
Bradford specifies Belgard hardscaping, and the line tiers matter to your bottom line. Entry-tier Belgard pavers with a standard base and polymeric sand land at the lower end of the $8,260 to $21,240 range. Mid-tier profiles – thicker units, a wider color range, a finished edge restraint – push toward the middle. Premium tier with a saw-cut or textured face, the hillside grade premium, and full sealing sit at the top. A 20-by-25-foot drive (500 square feet) reads like this: about $16 to $20 per square foot at entry level, $24 to $32 mid, and $35 to $42 premium installed. That’s a rough square-footage guide, not a bid; the base depth and stormwater solution swing it.
What goes wrong when the crew isn’t squared away
A paver driveway has three common failure points: a base that wasn’t compacted in lifts, edge restraints that weren’t set into concrete, and joint sand that was swept in wet instead of dry. Each one shows up inside the first rainy season. We do all three by the spec, and we put the scope in writing before any tool comes out. If the work fails within a year – base settling, restraints letting go, pavers shifting – the 365-Day Done Right Promise brings us back to correct it at no charge. That written guarantee is in your hand at job close, along with a clean site and a documented scope. We also work with GAF and CertainTea exterior materials on the building side, so a driveway repour and a roof replacement don’t turn into two separate conversations with two contractors.
FAQs
A paver driveway in Los Angeles typically costs $8,260 to $21,240 installed, and the range widens when a stormwater solution or an over-500-square-foot permeable requirement is triggered. The base course depth is the hidden driver: 6 to 8 inches of compacted base and geotextile fabric on expansive clay adds cost over a 4-inch standard base. Call (844) 343-6681 for an exact written quote – it’s free and it’s in writing before work starts.
A new or replacement driveway over roughly 500 square feet may need a permeable system or a catch basin and infiltration trench to manage runoff under LA’s low-impact development rules. The exact trigger depends on square footage, whether you’re replacing existing hard surface or adding new impervious area, and what LADBS plan check requires on your parcel. We confirm that before pricing, so you’re not budgeting for a requirement you don’t have. Call (844) 343-6681 and we’ll walk through it.
No – concrete driveway installation at $5,310 to $14,160 runs below paver on installed cost, and asphalt at $4,130 to $10,620 is lower still. Pavers cost more up front, but the assembly holds up better to the soil movement and seasonal wet-dry cycling this city sees, and you can pull and reset a single paver instead of pouring a patch. Call (844) 343-6681 for a side-by-side written price on both materials for your lot.
No – a real price needs a grade reading, a base-depth check and a stormwater review, and none of those happen from a photo. That’s exactly why we don’t quote numbers that move at the door: the price we put in writing is a written commitment before any work begins. Our technicians have up to 22 years of experience, so the site visit is quick and the questions are pointed. Call (844) 343-6681 to schedule your free estimate.
Get your driveway priced right the first time
One drive. One written number. A base built for LA clay, a spec that satisfies the stormwater rules, and a full-year guarantee behind it. Bradford Remodeling Co Los Angeles answers the phone with a live person 24/7 – no voicemail, no callback queue. Call (844) 343-6681 for your free estimate and get the price in writing before a single paver is set.
Written by the team at Bradford Remodeling Co Los Angeles, serving Los Angeles, CA.
What Our Customers Say
"Painting and drywall repair were flawless. They patched the drywall seams and the paint matches the old wall."
- Cal P."Respectful crew. Covered the floors and swept every day."
- Jackie T."Kitchen remodel run by a veteran-owned crew. They started on the day promised, kept the site clean, and gave weekly updates. New cabinets and counters look great."
- Alan M.












