







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Mr-Glass Fence Installation: The Los Angeles Owner’s Guide
Fence installation on a Mr-Glass system in Los Angeles typically runs $4,130 to $10,620 installed, depending on run length, grade change, and whether the job replaces an existing fence line or starts on open ground. We handle Mr-Glass-compatible fence installation with a written price before any work starts. Homeowners usually call us after a gate starts dragging, a post settles, or one section leans after a Santa Ana wind event. Those are the three signals that the original install is failing at the post or footing, not at the panel.
Key takeaways
- Installed range for Mr-Glass fence work in Los Angeles: $4,130 to $10,620.
- Every job gets a written price before work begins and the 365-Day Done Right Promise in writing at close.
- We’re an independent service provider, not affiliated with Mr-Glass. We install compatible systems and correct failed ones.
- Live person answers the phone 24/7 at (844) 343-6681.
Which Mr-Glass Models This Applies To

Mr-Glass runs glass and composite fence systems across several series, and the panel, post, and spigot specs change between them. Before we quote anything, we identify the system from three places: the stamp on the post cap or base plate, the panel edge profile (framed versus frameless), and the measured post spacing on center. A frameless glass system that reads 48 inches between posts is a different animal from a framed composite panel at 72 inches, and the footings are not the same.
That’s the compatibility gotcha most owners miss. Mr-Glass systems built for wind-exposed sites use a deeper, wider footing spec than the standard residential line, and installing a wind-rated panel on a standard footing is how fences fail in the first two years. If your property sits on a ridge, near the coast, or in a canyon corridor where gusts funnel through, say so up front. We’ll spec the footing to the panel, not the other way around.
On OEM versus aftermarket: for Mr-Glass specifically, OEM panels and posts make sense when you’re matching an existing run and need the profile to line up. For a full replacement on open ground, quality aftermarket equivalents in the same glass and composite grades perform comparably, and we’ll show you both prices side by side in the written quote. We don’t stock parts and we don’t carry parts on a truck. We source to the spec on your job.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Mr-Glass Fence Installation Is Failing
Fence failures in Los Angeles almost always trace back to the footing, the hardware, or the soil. Here’s what each symptom actually means.
- The gate drags or won’t latch. The hinge post has moved or the footing has shifted. A gate that dropped a quarter inch is telling you the post is rotating in the ground.
- One section leans after a wind event. Under-sized footing for the panel’s wind load, or soil that’s lost compaction. Common on hillside lots and canyon corridors.
- Panels rattle or flex in the frame. Worn spigots or gaskets, or screws backing out of the rail. Caught early, this is a hardware fix, not a panel replacement.
- Rust streaks or white corrosion at the base plate. Moisture sitting at the post base because the footing doesn’t drain. Coastal air speeds this up.
- Visible cracks or crumbling at the concrete collar. The footing itself is failing. This is the expensive one and the one that doesn’t fix itself.
Cracks in a footing or a post that’s rotating under load are structural. Don’t brace it and hope. Get it looked at.
Replacement Cost & What’s Included

Mr-Glass-compatible fence installation in Los Angeles runs $4,130 to $10,620 installed. Here’s what moves you up or down that range.
- Run length and panel count. More panels, more posts, more footings. The biggest single driver.
- Footing spec. Standard depth versus wind-rated depth for exposed sites. This is where cheap installs cut corners and where they fail.
- Grade change. A sloped lot means stepped panels and variable post heights.
- Removal and disposal. Hauling out an old fence line adds labor and dump fees.
- Gates and hardware. Self-closing hinges, latches, and gate posts sized to the leaf.
You get a written, line-item price before any work starts. No numbers that move at the door. When the job closes, you get a clean site, a documented scope, and the signed 365-Day Done Right Promise in your hand. If anything we installed fails within that year, we come back and correct it at no charge.
See the difference
Before
After
Before
After
Before
AfterDIY or Call Us?
You can safely check a few things yourself. Look at the base plate for rust or corrosion. Watch the gate swing and note where it binds. Measure post spacing and photograph the post cap stamp so you know which Mr-Glass series you have. Push on a post at hip height and see if it moves.
What you shouldn’t do is reset a footing or re-engineer post spacing yourself. A fence post carries real load, and a footing that’s under-spec’d for wind or soil can fail suddenly in a gust, taking the whole run with it. We’ve seen a lot of self-installed corrections that turned a $400 hardware fix into a full re-set. Our technicians have up to 22 years of experience reading exactly this failure pattern on Los Angeles properties.
Call (844) 343-6681 and we’ll give you a written price to fix it or replace it. A live person answers, 24/7. Estimates are free.
FAQs

A properly installed Mr-Glass system should hold 15 to 20 years on the panels and posts, but footing life is shorter. In Los Angeles soil, footings that don’t drain or weren’t spec’d for wind load typically show failure in 5 to 10 years. Call (844) 343-6681 for a free assessment of your footing condition.
Often yes. Worn spigots, loose gaskets, and backed-out screws are hardware repairs that cost far less than replacement. A cracked footing or a post rotating in the ground means at minimum a post reset, sometimes a full section. We’ll tell you which one you’re looking at before you spend anything.
A single-section hardware repair is usually a few hours. A post reset takes a day. A full run replacement depends on length and whether footings need to cure before panels go up, typically several days for a standard residential run. Your written quote includes the schedule.
We identify your series from the post stamp and panel profile, then source to that spec. For matching an existing run, we go OEM. For a full replacement, we’ll show you OEM and quality aftermarket equivalents in the quote so you can compare. We don’t carry stock, so lead time is part of every written price.
We also work with KraftMaid, Cambria, and Silestone on the interiors we remodel, so if your project touches the house as well as the fence line, one call covers both.
Get a Written Price on Your Mr-Glass Fence in Los Angeles
Bradford Remodeling Co Los Angeles is part of the Garrison Partners family, held to The Garrison Standard on every job. Our technicians are background-checked and uniformed, so you know who’s coming through your gate. We’ll look at your fence, tell you straight whether it’s a repair or a replacement, and hand you a written price before any work starts. Call (844) 343-6681 for your free estimate.
Written by the team at Bradford Remodeling Co Los Angeles, serving Los Angeles and nearby areas.












