







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Barrette Bathroom Remodeling: The Los Angeles Owner’s Guide
We install Barrette-compatible bathroom remodeling in Los Angeles, and a full bathroom remodel here typically runs $10,620 to $33,040 installed, with a written price before work starts. We schedule the assessment and quote within days, not weeks, so you’re not left with a half-finished bath. Most owners find us the same way: water pooling at the base of a shower pan, a vanity that has started to sag off the wall, grout lines opening along the floor, or a door that won’t close square.
Which Barrette Models This Applies To

Barrette makes a range of shower surrounds, pans, and accessories, and the part you need has to match your specific model line and dimension, not just the brand. A 60-inch pan from one Barrette series will not swap cleanly into a rough opening sized for another; the drain spacing and the tile flange geometry change between series and sometimes between vintages of the same series. Before you order anything, find the model label, usually a sticker on the back of the surround or under the pan lip, and measure your actual rough opening in three places: width, depth, and drain center off the back wall.
The OEM-versus-aftermarket call is where owners get burned. For Barrette surrounds and pans, an OEM replacement is the safe bet because the flange profile and drain alignment are fixed to the model. Aftermarket pans and drains are fine for many things, but the fit tolerance at the wall is tighter than a spec sheet suggests. We keep our sourcing tied to documented brands, and we’ve learned the hard way that “will fit Barrette” from a reseller is not the same as correct for your model. One note: Bradford Remodeling Co Los Angeles is an independent service provider and is not affiliated with Barrette.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Barrette Bathroom Remodeling Is Failing
Here’s what usually triggers the call, and what’s actually happening underneath:
- Water ring or soft spot at the pan perimeter. The caulk line has failed and water is getting behind the tile flange, which means the substrate behind it is wet and the pan seal is compromised.
- Vanity cabinet pulling away from the wall. Either the FastMount or lag fasteners have loosened from the studs, or the wall behind them has moisture damage and no longer holds a screw.
- Grout cracking along floor and wall joints. Movement from floor deflection or a shifting pan flexes the joints; the crack is the symptom, not the cause.
- Shower door that binds or won’t latch. The door track has shifted, often because the surround has moved, which points to a flange or substrate issue that started at installation.
- Mildew that returns within weeks of cleaning. Air and moisture are trapped behind a failed seal; surface cleaning won’t reach the source.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For a Barrette bathroom remodel in Los Angeles, plan on $10,620 to $33,040 for the full job. A small bathroom remodel runs $5,900 to $14,160; a tub-to-shower conversion is $4,130 to $11,800; a shower replacement alone is $3,540 to $10,030; and a walk-in shower installation runs $5,310 to $14,160. A vanity install by itself is $945 to $3,540.
What pushes you toward the top of the range in Los Angeles: substrate repair once the wall is opened, moving the drain to match a new pan, and tile work around a relocated valve. What’s included on our jobs: the written price before any tool comes out, the documented part and finish selection, substrate repair within scope, and the 365-Day Done Right Promise. If the work fails inside that year, we come back and correct it at no charge.
DIY or Call Us?
You can safely replace a failing bead of caulk, re-grout a hairline crack, and check a vanity’s fasteners for tightness. You should not open a wall to inspect the substrate, reset a shower pan, or move a drain line as a DIY job. Those sit behind the waterproofing, and a small miss there turns into a mold and rot problem that costs more than the original repair. We’re licensed, insured, and we give you a written price before we start. Call (844) 343-6681 and we’ll tell you whether the part is salvageable or the job needs a real fix.
FAQs

Most well-installed Barrette surrounds and pans hold up 15 to 25 years, but Los Angeles’s hard water and warm, humid interior air shorten that if the caulk line is neglected. Recaulking every two to three years is the single biggest thing you can do to stretch the lifespan.
Sometimes. A failed seal or a loose fastener can often be repaired in place. A cracked pan, a warped surround, or water damage behind the wall cannot be repaired – it has to come out. We’ll tell you which one you have after we look at it. Call (844) 343-6681 for a free estimate.
A single part replacement is usually a one- to two-day job. A full shower replacement or tub-to-shower conversion runs three to five working days once materials are on site and the permit, if required, is in hand. We confirm the schedule in writing before we start.
We match the part to your exact Barrette model and rough opening, then source through our documented brand roster so the spec and manufacturer warranty are traceable. We don’t guess at fit, and we don’t order from a reseller just because the listing says “fits Barrette.”
Whether your project is a Barrette bath or a full remodel using KraftMaid, Cambria, or Silestone, the next step is the same: a written price, no surprises. Call (844) 343-6681 for a free estimate.
Written by the team at Bradford Remodeling Co Los Angeles, serving Los Angeles and nearby areas.












