







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
ActiveYards Home Additions & ADU: The Los Angeles Owner’s Guide
We install ActiveYards-compatible home additions and ADUs in Los Angeles, and a full addition typically runs $53,100 – $153,400 while a detached ADU runs $106,200 – $259,600. Scheduling is planned work, not same-day: we survey, pull permits, and give you a written price before anything starts, so the timeline is measured in weeks, not hours. Owners usually come to this page after an ActiveYards structure has failed at a specific point – a hairline crack running up an exterior panel, a door that won’t sit square in its frame, or a ceiling that suddenly reads as a low spot under a light. When an addition is framed and finished around a manufacturer’s system, the failure shows up at the seams and connectors that were sized for a different climate than Los Angeles delivers. (Bradford Remodeling Co Los Angeles is an independent service provider and is not affiliated with ActiveYards.)
Key Takeaways
- An ActiveYards home addition in Los Angeles installs for $53,100 – $153,400; an ADU runs $106,200 – $259,600.
- Most failures show at panel joints, door frames, and roof-to-wall connections – not in the middle of a panel.
- We write the price before work begins, and every finished job carries the 365-Day Done Right Promise.
- DIY is safe for measurements and trim; structural, electrical, and gas work belongs with a trained crew.
Which ActiveYards Models This Applies To

ActiveYards builds modular additions and ADU shell systems, and the components are matched to the specific series and to the panel module width, not to the brand name alone. The first thing we do on a site visit is find the manufacturer’s label – usually riveted to an interior face of a panel or stamped on the frame of the door assembly, carrying a model and series code. That code is what we match, not a photo. Measure the panel width and the height to the nearest quarter inch, and measure the door rough opening at three points; a Los Angeles home built on a raised foundation can settle unevenly, and an opening that reads 36 inches at the top can read a half inch different at the bottom.
For ActiveYards specifically, the OEM-versus-aftermarket decision is real. Genuine ActiveYards panels and connectors keep the engineered assembly intact and preserve any manufacturer warranty that still applies. Quality aftermarket connectors and flashings can match the assembly and often cost less, but the fit has to be checked against the series – a connector sized for one panel module will not seat correctly on another, and a forced fit is where water gets in. We tell you plainly which components need the OEM part and which can safely take a quality equivalent, and the written quote lists each one by name.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your ActiveYards Home Additions & ADU Is Failing
- Hairline cracks running vertically from panel corners. The panel is moving against its connector. In Los Angeles, the daily thermal swing on a sun-facing wall works that joint hundreds of times a year until the seal gives.
- A door rubbing the strike plate or dragging on the sill. The frame has shifted, usually because the rough opening was not shimmed to the manufacturer’s spec. This one gets worse with each dry season.
- Staining or a low spot on the ceiling near the roof-to-wall junction. Flashing at the connection has failed. Our winter rain finds that joint fast, and a ceiling stain means the water has been traveling for a while.
- Gaps at seams you can see daylight through. The panel-to-panel seal has opened, either from failed gasketing or from a connector that was undersized for the module. This is the classic ActiveYards failure in Los Angeles’s dry, hot inland stretches.
- A spongy or uneven floor at the entry threshold. Moisture has reached the subfloor where the addition meets the house. Left alone, this spreads into the framing and the repair cost climbs quickly.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Replacement and re-fit work on an ActiveYards assembly is priced by scope, and these are the ranges we hold in Los Angeles:
| Scope | Installed Price Range |
|---|---|
| Home Addition | $53,100 – $153,400 |
| ADU Construction | $106,200 – $259,600 |
| Garage Conversion | $35,400 – $94,400 |
What drives the number: the size and number of panels, whether the roof and flashing get rebuilt or repaired, foundation condition, and whether the door and window assemblies are reused or replaced. The quote is line-item and written before any work starts. Parts and labor are listed separately so you can see exactly what the ActiveYards-compatible component costs against the installation. Every completed project carries the 365-Day Done Right Promise: a full-year written guarantee, and if the work fails inside that window we come back and correct it at no charge.
DIY or Call Us?
You can safely measure panels, photograph the model label, and check trim and gutters for movement. What you shouldn’t take on yourself is anything structural or anything connected to power or gas. An addition or ADU involves load-bearing framing, rough electrical, and often gas lines, and a mistake in any of those is a genuine hazard, not just an expensive one. We say that plainly because we’ve seen the aftermath – a homeowner’s re-flash that trapped water instead of shedding it, a door frame shimmed to close the gap while the real settlement went unaddressed. It’s the kind of work that needs a trained crew and a permit pulled. Our technicians have up to 22 years of experience, and we are background-checked and uniformed. Call (844) 343-6681 for a free estimate – we’ll survey the ActiveYards structure and put the price in writing.
FAQs

An ActiveYards-compatible addition, installed correctly and flashed properly, should hold its seals and structural connections for 20-plus years in Los Angeles. The variable is installation quality at the joints, not the panels themselves – a correctly shimmed and flashed assembly lasts far longer than one where the connectors were forced. Call (844) 343-6681 for a free survey of your structure.
Often, yes. A single failed flashing, a shifted door frame, or a cracked panel section can usually be repaired and re-sealed without rebuilding the whole addition. We inspect first and tell you honestly whether repair is the right call or whether replacement is more cost-effective. Call (844) 343-6681 for an exact quote – estimates are free.
A targeted repair can be a few days; a full home addition or ADU runs significantly longer given permits, framing, and finish work in Los Angeles. We give you a schedule in writing with the price before work starts. Call (844) 343-6681 to schedule your free estimate.
We match the component to the model and series code on your structure’s label, then source the genuine ActiveYards part or a quality aftermarket equivalent where it’s a safe fit. We do not keep parts in stock or carry them on a truck – each order is matched to your specific assembly. Call (844) 343-6681 and we’ll walk you through the sourcing on your job.
No. The written, line-item price we give you before work begins is the price, with no moving numbers at the door. Any change comes only from you approving added scope in writing. Call (844) 343-6681 to get your estimate on record.
If you’re in Los Angeles and an ActiveYards addition or ADU needs attention, we work from a documented roster of name-brand materials across our projects – KraftMaid, Cambria, and Silestone among them – so whatever the scope around your ActiveYards structure, the specifications are traceable. Call (844) 343-6681 today for a free estimate. A live person answers, and every price comes in writing before a single tool comes out.
Written by the team at Bradford Remodeling Co Los Angeles, serving Los Angeles and nearby areas.












