







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Sakrete Fence Installation: The Los Angeles Owner’s Guide
Sakrete fence installation is a post-setting and panel-assembly job, not a part swap – Sakrete is the concrete mix and anchoring system that holds fence posts, not a mechanical component that fails in place. In Los Angeles, a full vinyl fence installation that uses Sakrete for post setting runs $4,130 to $10,620 installed, and aluminum runs $4,720 to $11,800. We schedule these installations as planned work, usually within one to two weeks of an approved written estimate, because post holes have to be inspected before any mix goes in.
Owners usually find us after a winter windstorm or a soil shift leaves a post loose and the gate dragging. Sometimes it’s a fence that was set with dirt instead of concrete, or with a fast-set mix that wasn’t mixed to the right ratio. The symptom is always the same: a post that rocks in its hole, a panel out of plumb, and a gate that won’t latch without a lift.
Which Sakrete Products This Applies To

Sakrete makes several mixes that get used for fence posts in Los Angeles, and the choice matters for how long the post stays put. The two you’ll see most are Fast-Setting Concrete Mix (sets in about 20 to 40 minutes, sold in 50 lb bags) and High-Strength Concrete Mix (sold in 80 lb bags, needs a longer cure but reaches higher compressive strength). There’s also a Post Setting Mix in some regional lineups that’s formulated specifically for wood and metal posts without bracing. If you’re holding a bag, the product name and weight are printed on the front panel and the mixing ratio is on the back – that’s your identifier, not a model number, because Sakrete doesn’t use model numbers the way an appliance does.
Here’s the compatibility gotcha worth knowing: Fast-Setting is not the right pick for every post. It’s convenient for a single mailbox post, but for a fence line in Los Angeles clay or the sandy soils near the Ballona Creek corridor, the High-Strength mix is the better call because it cures slower and gives you time to plumb the post before it locks. Use the wrong mix and you get a post that’s set at a slight lean you can’t correct without breaking it out.
On the OEM-versus-aftermarket question: Sakrete is a Quikrete-adjacent brand with strict formulation, and there’s no “aftermarket equivalent” that matches it spec-for-spec. The honest choice is between named Sakrete mixes and a competitor’s mix, not between Sakrete and a knockoff. We work with a documented roster of name-brand materials so every bag and every post is traceable – the same discipline we apply to the KraftMaid, Cambria, and Silestone products we install on interior work. We don’t stock Sakrete and we don’t carry it on a truck; we specify it, source it for your job, and set the posts to the manufacturer’s ratio.
Bradford Remodeling Co Los Angeles is an independent service provider and is not affiliated with Sakrete.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Sakrete Fence Installation Is Failing
- The post rocks when you lean on it. That means the concrete collar has cracked away from the post or the hole was under-filled. In Los Angeles, our dry summers shrink clay soil, and a post set in an undersized hole will start to move within a few seasons.
- The gate sags and won’t latch. A gate is the heaviest load on a fence line, and if the hinge post wasn’t set deep enough or the mix wasn’t High-Strength, the post tips a fraction of an inch and the whole gate follows.
- Cracks radiating from the base of the post. Visible cracking in the Sakrete collar usually means the mix was too wet when poured, which weakens it. Fast-Setting mix poured at the wrong water ratio is the usual culprit.
- Panels that are out of plumb but the posts look fine. This is a panel or rail problem, not a concrete problem, and it’s often a sign the original install skipped bracing while the mix cured.
- Water pooling at the post base after rain. Los Angeles gets concentrated rain in a short window, and a post set without a crown of mix sloped away from the wood will soak and rot at the ground line.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

For Los Angeles, a full vinyl fence installation that includes Sakrete post setting runs $4,130 to $10,620. Aluminum fence installation runs $4,720 to $11,800. Those are installed prices, not material-only. Here’s what drives the range:
- Linear footage and post count – more posts means more bags of mix and more hole digging.
- Fence height and style – a 6-foot privacy panel loads the posts harder than a 4-foot picket, which changes how deep and how wide each hole has to be.
- Soil conditions – Los Angeles clay and the sandy pockets near the coast both require different hole depths to hit stable bearing.
- Gate count – each gate adds a heavier hinge post and hardware.
Every price is written before any work starts. No numbers that move at the door. If the work fails within a year, the 365-Day Done Right Promise means we come back and correct it at no charge – and that guarantee is in writing, in your hand, at job close. The site gets cleaned up, the scope gets documented, and you get a signed guarantee. That’s what squared away looks like.
DIY or Call Us?
There’s a safe split here. You can absolutely check your own fence. Walk the line, push on every post, open and close every gate, and look for cracks at the concrete collar. You can measure post spacing and note which posts are loose. That information is useful and it costs nothing.
Where DIY goes wrong is the digging and the mix. A fence post hole in Los Angeles clay is hard work, and the most common homeowner mistake is a hole that’s too shallow or too narrow – the mix sets, the post feels solid, and then a season of shrink-swell soil loosens it. The second mistake is mixing Fast-Setting at the wrong water ratio, which quietly weakens the collar. Neither problem shows up on day one. Both show up two years later.
If you want the post set right the first time, call (844) 343-6681 for a free written estimate. A live person answers, day or night.
FAQs

A post set properly with High-Strength Sakrete mix in a correctly sized hole typically holds for 15 to 25 years in Los Angeles conditions, assuming the post itself is a rot-resistant material. The concrete is rarely what fails first – the wood or the panel is. Call (844) 343-6681 for an exact quote on your fence line; estimates are free.
Often yes. A single loose post can sometimes be reset or sistered to a new post without pulling the whole line, and that’s usually the first thing we evaluate on a site visit. If the concrete collar is cracked and the post is sound, a reset is the cheaper path. If multiple posts are moving, a full reinstall is the honest recommendation. Call (844) 343-6681 to schedule a free estimate and we’ll tell you which one your fence needs.
A typical residential fence line in Los Angeles takes two to four days from hole digging to final panel set, depending on linear footage and how many gates are involved. The Sakrete mix itself cures fast, but the posts need bracing time before panels go on. Call (844) 343-6681 for a written timeline with your estimate – the schedule is in the price, not a promise made at the door.
We specify the correct Sakrete mix for your soil and post type, then source it through our documented supply chain so the bag, the ratio, and the batch are traceable. You’ll see the product named on your written scope. Call (844) 343-6681 for a free estimate and we’ll walk you through the spec before any work starts.
Written by the team at Bradford Remodeling Co Los Angeles, serving Los Angeles and nearby areas.












