







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Tamko Home Additions & ADU: The Los Angeles Owner’s Guide
We build Tamko-compatible home additions and ADUs in Los Angeles, and a typical finished addition runs $53,100-$153,400; a detached ADU runs higher, at $106,200-$259,600. Those figures are for the whole project, not a single component. When we talk about a failing Tamko “part” here, we mean the weather barrier and roof-to-wall flashing that sit behind the first course of siding, not a garage-door spring or electrical fitting. That detail is usually discovered the same way: a brown stain on a ceiling near an exterior wall, a soft spot under a window, or a bubbling paint line after the first big rain of the season.
Which Tamko Models This Applies To

Tamko is best known for roofing shingles (the Heritage and Titan lines) and for its waterproofing underlayments (Twist-Lock, Shingle-Mate, and the Weather Star family). On an addition or ADU, the Tamko product sitting behind your finished wall is the underlayment layer; the shingles are the part you see from the street. Identifying the right replacement means matching the underlayment to what the existing assembly uses, not guessing from the brand alone.
Three things to check before ordering anything:
- Package label or installed photos. If you have the original contractor’s submittal, the underlayment product code is on it. If you don’t, a licensed installer can pull a small section at a corner and read the exposed membrane.
- Width and overlap. Underlayments come in specific roll widths (commonly 36 inches) and are installed with a stated overlap (commonly 4 inches side, 6 inches end). Measuring what’s there tells you what’s compatible.
- OEM vs. aftermarket. A quality aftermarket equivalent (synthetic instead of felt, equivalent to the Weather Star line) is a legitimate choice if the rest of the assembly is synthetic. Mixing a felt underlayment under a synthetic system, or the reverse, is where compatibility problems start.
Your Los Angeles climate is a real variable here. The South and West sides of a building take the worst UV load; the North side holds moisture the longest after a marine-layer morning. If your addition faces west and sits under a low-slope assembly, the underlayment choice matters more than it does on a shaded north-facing wall.
Bradford Remodeling Co Los Angeles is an independent service provider and is not affiliated with Tamko; we specify and install compatible materials and install them to the same standard we’d apply to any documented brand on our roster, including KraftMaid, Cambria, and Silestone on the interior side.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Tamko Home Additions & ADU Is Failing
Five symptoms we consistently find on Los Angeles additions and ADUs, and what’s actually behind each one:
- Water staining on a ceiling or interior wall near an exterior edge. That’s almost always a flashing or underlayment breach at the roof-to-wall intersection, not the shingles themselves. Underlayment is the last defense; if water got in, it failed first.
- Wrinkled or delaminated membrane visible at a corner or edge. Synthetic underlayments wrinkle when installed at the wrong temperature or over a wet substrate; the wrinkles collect water, then the membrane delaminates from the sheathing. In a Los Angeles summer, the UV load on an exposed edge accelerates this.
- Bubbling or blistering on the siding or stucco face. That’s often a sign that moisture got behind the weather barrier and can’t dry out. On low-slope ADU roofs, the underlayment is the culprit more often than the visible roof covering.
- Musty smell inside the addition after the first wet season. If the interior smells musty after rain but the ceiling looks fine, the failure is behind the finish and the underlayment layer is a primary suspect.
- Loose fasteners or torn membrane visible during a visual inspection of an exposed section. Fastener patterns matter; underlayments are specified for a cap pattern at the edges and a field pattern elsewhere. Sloppy fastening is a common install fault and a common failure.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Installed pricing for a Tamko-compatible underlayment and flashing correction in Los Angeles breaks out roughly like this:
| Item | Installed Price Range |
|---|---|
| Underlayment removal and replacement (small addition section) | $945-$2,950 |
| Roof-to-wall flashing correction | $470-$2,125 |
| Full underlayment and flashing scope on a typical ADU roof | $9,440-$23,600 |
| Home addition project-level budget (full build or rebuild) | $53,100-$153,400 |
| ADU construction, full project | $106,200-$259,600 |
What drives the range: the size of the area, whether the existing sheathing has to come off, whether the assembly is pitched or low-slope, and whether the flashing correction exposes more scope once the wall is open. You get a written price before any work starts. That’s how The Garrison Standard works: no number that moves at the door. Every completed repair carries the 365-Day Done Right Promise, and if the work fails within the guarantee period, we return and correct it at no charge.
DIY or Call Us?
What an owner can safely do: note the symptom, photograph what you can see from the ground, and check the original contractor paperwork for the underlayment specification. What you shouldn’t do: pull back shingles or siding on a pitched roof, get onto a low-slope assembly to inspect a suspect membrane, or attempt a flashing repair on a multi-story wall. Roof-level work is genuinely dangerous. It’s the one part of this job where a fall outweighs any cost you’d save, and a water intrusion you misdiagnose gets worse with every rain.
On a Los Angeles addition or ADU, underlayment and flashing failures are exactly the kind of repair that hides its full extent until the wall opens. A licensed tech diagnoses it once, in writing, and gets it right the first time. Call (844) 343-6681 for a free estimate; a live person answers, not a voicemail.
FAQs

High-quality synthetic underlayments are commonly rated for 25-30 years of exposure, but exposed underlayment on an unfinished addition in Los Angeles can degrade faster under direct sun, often within 6-10 years if left uncovered. Once the roof covering and siding are in place, the underlayment’s lifespan is measured by the assembly and the detailing, not the product alone. Call (844) 343-6681 for an exact assessment – estimates are free.
Sometimes. A single localized flash failure or a small flashing correction can often be repaired without pulling the full underlayment layer. If the membrane itself is delaminated or the failure is at a corner, full replacement of the affected section is the honest call. We’ll tell you which case you’re in, in writing, before any work starts. Call (844) 343-6681 for a free estimate.
A localized underlayment and flashing correction on a single addition wall typically takes one to two days; a full underlayment scope on an ADU roof typically runs three to five working days, weather permitting. Larger scopes run longer. The written price includes the timeline, so you know before the crew shows up. Call (844) 343-6681 for an exact quote.
Through documented suppliers with manufacturer spec sheets and warranties that back our own guarantee. We’re independent and not affiliated with Tamko; when a Tamko-compatible product is the right match, we specify it, and when a quality aftermarket equivalent serves the assembly better, we specify that. Either way, the specification is written and traceable. Call (844) 343-6681 for a free estimate.
Not for the scope on the written estimate. If we open the wall and find more damage than the estimate covered, we stop and put the additional scope and price in writing before continuing; you approve or we don’t proceed. The Garrison Code exists for exactly that moment. Call (844) 343-6681 for a free estimate.
Yes. Structural work on an addition or ADU in Los Angeles requires permits, and we pull them and see the inspections through as part of the scope. That’s non-negotiable on this work; an unpermitted addition or ADU is a problem at resale and a problem at insurance time. Call (844) 343-6681 for a free estimate.
A full addition typically runs several months from permit to close; a detached ADU runs longer, and both depend on the permit timeline in your part of Los Angeles. A localized repair runs days, not months. The written scope on your estimate states the timeline for your specific job. Call (844) 343-6681 for a free estimate.
Yes. Every technician on a Bradford Remodeling Co Los Angeles job is background-checked and uniformed, so you know exactly who is on your property before the crew arrives. Our technicians have up to 22 years of experience, and identity and conduct standards are set at the Garrison Partners level. Call (844) 343-6681 for a free estimate.
Every completed repair or remodel carries a full-year written guarantee. If the work fails within that window, we return and correct it at no charge. The guarantee terms are in your paperwork before the job starts, so you know the coverage in writing. Call (844) 343-6681 for a free estimate.
No. We’re an independent service provider and not affiliated with Tamko. We specify and install compatible materials to manufacturer spec and back our work with our own written guarantee. Call (844) 343-6681 for a free estimate.
If you have a Tamko-compatible addition or ADU with water intrusion, a visible membrane failure, or a musty smell after rain, the honest next step is a free estimate and a written scope, not a call to a general handyman. We work in Los Angeles and the surrounding areas, we answer the phone 24/7 with a real person, and we put the price and the guarantee in your hand before any work begins. Call (844) 343-6681 to schedule your free estimate.
Written by the team at Bradford Remodeling Co Los Angeles, serving Los Angeles and nearby areas.












