







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Wellborn Fence Installation: The Los Angeles Owner’s Guide
Wellborn fence installation in Los Angeles typically runs $4,130 to $10,620 installed, depending on linear footage, material, and how much site prep your property needs. We install fence systems matched to Wellborn specifications for Los Angeles homeowners, and we can usually get a written quote to you and a crew scheduled within the week. Owners rarely think about the fence until something gives: a gate that drags, a post that leans after the first heavy rain, or panels that have gone chalky and gray faster than the neighbor’s did. Bradford Remodeling Co Los Angeles is an independent service provider, not affiliated with Wellborn.
- Typical installed range: $4,130 – $10,620
- What’s included: Removal of the old fence, post footings, materials, labor, cleanup
- Written price: Delivered before any work starts, no change orders at the door
Which Wellborn Models This Applies To

Wellborn’s fence lines run across several series, and the exact panel and post spec changes between them. Before we quote, we identify your model by the stamp on the post cap or the label inside the gate frame, then measure actual post spacing and panel height on site. That step matters: Los Angeles properties are full of mismatched fences where a previous owner mixed series, and a panel built for one series won’t seat cleanly into posts from another.
The OEM-versus-aftermarket call is where most homeowners get talked into the wrong thing. Wellborn-branded components carry the manufacturer’s own spec and warranty, and on a fence that’s the difference between a post rated for the load and one that’s merely close. Quality aftermarket equivalents exist for hardware and fasteners, and we’ll tell you plainly when one is fine and when it isn’t. What we don’t do is claim we stock parts or carry them on a truck. We source what your Wellborn model needs, and we document the part numbers before the crew shows up.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Signs Your Wellborn Fence Installation Is Failing
Fence failures announce themselves slowly, then all at once. These are the five we see most in Los Angeles:
- Leaning or wobbly posts. Usually a footing that wasn’t set deep enough for the soil, or water pooling at the base after a wet season. Once a post loses its plumb, the panels pull against each other.
- Gate that drags or won’t latch. Often a hinge that’s worn past its tolerance or a post that has shifted a quarter inch. Small movement, big annoyance.
- Chalky, faded panels. Southern California’s UV load is brutal, and lower-grade finishes break down years ahead of spec. If the surface rubs off white on your hand, the coating is gone.
- Loose or popped fasteners. Rusted screws and backed-out nails point to moisture intrusion or a fastener sized wrong for the material.
- Cracked panels or split rails. Usually from ground movement or from a tree root heaving the footing. Cracks widen fast once water gets inside.
If you’re seeing two or more of these, the fence is past patching. Call (844) 343-6681 for a free estimate and we’ll tell you straight whether it’s a repair or a full run.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included

Installed Wellborn fence replacement in Los Angeles lands between $4,130 and $10,620. The low end covers a straightforward run with easy access and standard material. The high end covers longer linear footage, tighter lot lines, gates, and demo of an old fence that’s set in concrete.
What drives the range: linear footage, material and series, number of gates, footing depth required by your soil, and whether old posts have to be pulled from concrete. Every quote is line-item, so you can see the split between materials and labor. No number moves once work starts.
All completed work carries the 365-Day Done Right Promise: if the fence fails within a full year, we come back and correct it at no charge. You’ll have a written guarantee in your hand at job close, along with a clean site and a documented scope. We also install and service KraftMaid, Cambria, and Silestone lines where a project calls for them.
DIY or Call Us?
You can safely walk the fence line and check for lean, loose fasteners, and surface chalk. Take photos. Measure post spacing. That’s useful prep, and it helps us quote faster.
Where DIY goes wrong: digging and setting footings to the depth your soil and code actually require, pulling old posts set in concrete without cracking the adjacent panels, and matching panel-to-post spec across series. Setting a fence post improperly is how a brand-new fence starts leaning in year two. On a Los Angeles lot with hard clay or an old concrete footing, hand work is where the weekend project turns into a three-week mess. One honest call saves that. Ring (844) 343-6681 and we’ll give you a written price before anything gets dug.
FAQs

Most Wellborn fence lines last 15 to 20 years in Los Angeles conditions, with the finish usually failing before the structure does. Our inland sun and dry summers wear coatings faster than coastal fog does, so a fence in the Valley often needs refinishing or panel replacement years before one near the beach. Call (844) 343-6681 for an exact quote.
Sometimes. A single leaning post, a dragging gate, or a handful of popped fasteners are repairable. Once panels are cracked, posts are set in failed footings, or the finish is chalked out, replacement costs less than chasing repairs. We’ll tell you which one you’re looking at during the free estimate.
A standard residential fence run in Los Angeles takes one to three days, depending on linear footage, gate count, and how stubborn the old footings are. We give you the schedule in writing with the quote, and the 365-Day Done Right Promise covers the work for a full year after close.
We identify your Wellborn series from the post cap stamp or gate label, measure on site, and pull the matching spec from the manufacturer. We don’t claim to stock parts or carry them on a truck. Part numbers are documented before the crew arrives, so nothing is guessed at the door. Call (844) 343-6681 and we’ll walk you through it.
Written by the team at Bradford Remodeling Co Los Angeles, serving Los Angeles and nearby areas.












